SERVICE CENTER

Series of simple and versatile machines enabling the assembly and maintenance of diamond tools for the stone and building industries.

 
WELDING BENCHES
Over 96 Benches sold worldwide up to now
 
SC 23-200
CIRCULAR BLANKS & GANG SAWS

Characteristics >>


Welding Device for discs and gang saw blades working in horizontal position with acetylene-oxygen torch.

  • Minimum blank carrying spindle of 16 mm diameter,
  • Welding bridge displacement, with pneumatic brake,
  • Blank-locking pads with water cooling, the upper one triggered by a non-swivelling pneumatic piston,
  • Adjustable segment-carrying pad, with variable water cooling ; the pad has oblique adjustment (conical segments) and his position is controlled by a clock gauge (stroke length : 10 mm) with in-built locking,
  • Cooling circuit with in-built stainless steel water tank and pump, with continuously variable water flow.

Technical Data

  • Capacity :    Circular discs and blanks from diameter 230 up to 2,000 mm

       Gang saw blades of any length (by adding lateral benches)

  • Maximum blank thickness : 40 mm
  • Maximum water flow rate : 4 l/min
  • Capacity of water tank : 160 litres
  • Power supply : 220 V, 50 Hz (0.3 kW)
  • Compressed Air at 6 bars (in-built adjustment and manometer)

Dimensions and Weight

  • Length : 1,130 mm
  • Width : 1,200 mm
  • Total Height : 1,150 mm               Working Height : 860 mm
  • Weight (empty) : 100 kg

Normal accessories

    • 1 dial gauge,
    • Instruction Manual

 

 
 
SC 120
DRILL BITS
Characteristics >>


This equipment easily allows the welding of segments on hollow drill bits, as well as the control and eventual correction of lateral run-out and concentricity of the bits. In-built Water tank and pump, as well as a swivel-arm carrying the bit spindle with different adaptors.

Technical Data

  • Maximum drill bit diameter for segment brazing : 1,200 mm,
  • Maximum drill bit diameter for checking and correcting the concentricity : 300 mm,
  • Water tank capacity : 90 litres,
  • Power supply: 380 V, three-phased, 50 Hz.

Dimensions and Weight

  • Width : 500 mm
  • Length : 1,100 mm
  • Height : 950 mm
  • Weight : 90 Kg (empty)

Normal accessories

  • 1 Dial Gauge,
  • 2 sets of 10 pieces each of distance magnets,
  • Double connector (1/2” GAS and 1 ¼” UNC)
  • Instruction Manual.

Special accessories
 

  • Double connector (1/2” GAS and 1 ¼” UNC),
  • Simple connector (Thread on request)
  • Set of distance magnets (0.5 – 0.75 – 1.0 – 1.25 mm on choice)
  • Plasma Generator with reduction gear and motor (when cutting the rim of used drill bits is required for re-tipping)